When a moving company asks whether there is a lift, do not stop at yes. The cabin may be large but its doorway narrow. There may be steps between the street and the lift, or the lift may stop at a different level from your apartment. These details change the work even over a short distance. Checking them early lets the company decide which items can use the lift and which need another route.
Trace the route from the vehicle to the room
- Measure the clear door opening, then the cabin width, depth and height. Record the stated load capacity without exceeding it.
- Photograph turns between the building entrance, lift and apartment door, respecting other residents’ privacy.
- Identify steps, thresholds and self-closing doors. Ask building management about lift use and protection during the move.
- Repeat the checks at the new address. Getting furniture out of one home does not prove that it will fit into the next.
Compare measurements with the item in its intended transport condition, not just catalogue dimensions. Packaging and parts that cannot be removed may require extra space. If the fit is close, send the details to the company for assessment rather than forcing a trial. Do not remove a lift door or safety component to widen the opening.
When is a visit worthwhile?
A visit is particularly useful when a long item meets a tight corner, the lift capacity is unclear, or the route crosses a sensitive shared area. A long table might fit inside the cabin but be impossible to turn in front of its door. The relevant measurement is the whole route, not one rectangle at the end.
A common mistake is writing “lift available” and expecting the team to resolve every difference on arrival. Alternative equipment or arrangements may not be available immediately. Suva stresses suitable handling aids for loads. A small lift should not become a reason to attempt an improvised, unsafe carry on the stairs.
Write the measurements and floors for both addresses, a description of tight turns and any agreed lift-use times in your REQAVIA request. After contacting the company, share the necessary photographs with it directly. Ask about alternatives and how changes would be handled before agreeing. Confirm the work and price using verified information, and identify any points that still need an inspection.
